Cambium Networks PTP 820C, Руководство пользователя

Страница: 199 / 672

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3963_004v000
Page 6-6
Note
Additional configuration of the MAC address table can be performed via the CLI. See
Defining the MAC Address Forwarding Table for a Service .
9. In the Default CoS field, enter a default Class of Service (CoS) value (0-7). This value is
assigned to frames at the service level if CoS Mode is set to Default-CoS. Otherwise, this value
is not used, and frames retain whatever CoS value they were assigned at the service point or
logical interface level.
10. In the CoS Mode field, select one of the following options. This parameter determines whether
or not frames passing through the service have their CoS modified at the service level. The
CoS determines the priority queue to which frames are assigned.
o
Default CoS – Frames passing through the service are assigned the default CoS defined
above. This CoS value overrides whatever CoS may have been assigned at the service
point or interface level.
o
Preserve-SP-COS-Decision – The CoS of frames passing through the service is not modified
by the service's default CoS.
11. Click Apply, then Close to close the Ethernet Services - Add page.
12. Add service points. You must add service points to the service in order for the service to carry
traffic. See
Configuring Service Points .
Editing a Service
To edit a service:
1. Select Ethernet > Services. The Ethernet Services page opens ( Figure 117 ).
2. Select the service in the Service Configuration Table.
3. In the Ethernet Services page, click Edit. The Ethernet Services - Edit page opens.
4. This page is identical to the Ethernet Services - Add page ( Figure 118 ). You can edit any
parameter that can be configured in the Add page, except the Service ID.
Deleting a Service
Before deleting a service, you must first delete any service points attached to the service.
To delete a service:
1. Delete all service points attached to the service you wish to delete, as described in Deleting a
Service Point .
2. Select Ethernet > Services. The Ethernet Services page opens ( Figure 117 ).
3. Select the service in the Ethernet Service Configuration Table.
4. Click Delete. The service is deleted.