Cambium Networks PTP 820C, Руководство пользователя

Страница: 200 / 672

Chapter 6: Ethernet Services and Interfaces Configuring Ethernet Service(s)
phn-3963_004v000
Page 6-7
Enabling, Disabling, or Deleting Multiple Services
To enable, disable, or delete multiple services:
1. Select Ethernet > Services. The Ethernet Services page opens ( Figure 117 ).
2. Select the services in the Ethernet Services Configuration table, or select all the services by
selecting the check box in the top row.
o
To enable the selected services, in the Multiple Selection Operation section underneath the
Ethernet Services Configuration Table, select Operational and click Apply.
o
To disable the selected services, in the Multiple Selection Operation section underneath the
Ethernet Services Configuration Table, select Reserved and click Apply.
o
To delete the selected services, select Delete underneath the Ethernet Services
Configuration Table. Before deleting a service, you must delete any service points attached
to the service, as described in
Deleting a Service Point .
Figure 119 Multiple Selection Operation Section (Ethernet Services)
Note
When setting multiple services to Reserve state, make sure to avoid setting the
management service to Reserve state.
When setting multiple services to Reserve state, make sure to avoid setting the management
service to Reserve state
Viewing Service Details
To view the full service parameters:
1. Select Ethernet > Services. The Ethernet Services page opens ( Figure 117 ).
2. Select the service in the Ethernet Services Configuration table.
3. In the Ethernet Services page, click Service Details. The Ethernet Services – Service Details
page opens. The Service Details page contains the same fields as the Add page (
Figure 117 ).
However, in the Service Details page, these fields are read-only.
Configuring Service Points
This section includes:

Ethernet Services Points Overview

The Ethernet Service Points Page
 Adding a Service Point

Editing a Service Point