Problems on the Road
. . . 414
2. If the cable is not visible,
proceed to step 4.
If the cable is visible, tighten
the cable by turning the wheel
wrench clockwise until it clicks
or skips twice.
The cable cannot be overtight-
ened.
Loosen the cable by
turning the wheel wrench
counterclockwise three or four
turns.
Tighten and loosen the cable
at least two times.
If the tire lowers to the ground,
continue with Step 11 of this
procedure.
If the tire does not lower to the
ground, continue with this
procedure.
3. Turn the wrench counterclock-
wise until approximately
15 cm of cable is exposed.
4. Stand the wheel blocks on
their shortest end, with the
backs facing each other.
5. Set the bottom edge of the
jack on the wheel blocks,
separating them so that the
jack is balanced securely.
$10araEscalade.fm Page 414 Wednesday, October 14, 2009 9:52 AM