Cabletron Systems MMAC-Plus SFCS-1000, Руководство по настройке

Страница: 174 / 404

B-22
AMI Configuration Commands
B.5.1.4 Displaying BUS Information
This command lets the user display the current BUS information in one of
two ways. To display information about every BUS that is currently config-
ured on the switch, enter the following parameters:
localhost::configuration lane bus>
show
Index AdminStatus OperStatus Selector Name
1 up up 0x0b marketing
The fields in this display are defined as follows:
Index Shows the unique, positive integer index that identi-
fies this BUS. It is dynamically assigned by AMI
when the BUS is created.
AdminStatus Reflects any changes that the user has made to the
status of the BUS.
Up
means the user started the BUS.
Down
means the user stopped the BUS.
OperStatus Reflects the actual current status of the BUS. Up
means the BUS is currently active. Down means the
BUS is currently inactive.
Selector Displays the selector byte portion (20th byte) of the
ATM address of the host or switch that is the BUS in
hexadecimal format.
Name Lists the name of the ELAN that this BUS services.
NOTE:
When you change the administrative status
of a BUS from
down
to
up
, it takes a few sec-
onds for the operational change to occur and
to be reflected in the
OperStatus
field. There-
fore, it is possible for the information above
to show the
AdminStatus
as
up
, but the
OperStatus
as
down
. If you show the infor-
mation again after two or three seconds, the
change will have taken place and be reflected
here.