CAB 4414 Series, Руководство по обслуживанию

Страница: 15 / 39

15 5 Installation
5.5 Mounting the Applicator to the Printer
1
1
2
2
6
7
3
4
5
8 9 10
Fig. 10 Mounting applicator on printer
!
Attention!
Initiation, adjustments and changing of parts is only for qualified service personal only.

Service Manual
Mount the applicator
1. Hang the applicator with the female part of hinges (1) at the printer mounted hinges parts (2).
2. Connect SUB-D 15 male connector (6) to the female connector (7) of the printer.
3. To prevent the applicator from slipping out of the hinges loosen screw (4) and move the locking plate (3) under the
hinges and tighten screw (4).
4. Swing the applicator to the printer and tighten the thumbscrew (5).
5.
Keep the external compressed air supply closed and close the shut-off valve (10) on the applicator

see
illustration
6.
Insert external compressed air supply (8) into the plug connector (9) on the shut-off valve (10).
7.
Switch on compressed air and open shut-off valve (10) by turning 90 °.
For cleaning the applicator and printer it's sometime necessary to turn away or/and dismount the applicator.
Don't change the adjustments of setting screws, throttle valves or other.
Turn away/Dismount the applicator
8. To turn away the applicator loosen thumbscrew (5) and swing the applicator aside.
9. Disconnect SUB-D 15 male connector (6) to the female connector (7) of the printer.
10.
Loosen screw (4) and move off the locking plate (3) from the hinges.
11. Lift the applicator upward.