25
6.7
Adjustment of the Stopper for Blow Mode
i
Note!
For operation mode "Blow on" only!
The operation mode "Blow on" allows labelling without contact.
The pad does not press on the product. The label will be blown from the pad onto the product over a distance of
up to 10 mm.
!
Attention!
Switch off the printer and close the shutoff valve of the compressed air via the shut-off valve!
3
1
2
6
7
5
4
8
1. Place a product sample (7) at the labelling point.
2.
Pull the tubes out of the push-in-fittings (3,5).
3. Loosen the screw (2) in the stopper (1).
i
Note!
In case you move the tamp assembly manually
move in the Y-cylinder. So that the tamp
doesn't touch the dispense plate or blow tube
during movement.
4. Move the pad manually in the required labelling position.
The distance between the blow pad (6) in the labelling
position and the product surface (7) must not exceed 10
mm.
5. Move the stopper (1) along the guide block (4) and tighten
the screw (2)
6.
Insert the tubes into the appropriate push-in-fittings (3,5).
7.
Open the shutoff valve and switch on the printer.
i
Note!
To reduce the impact energy of the tamp it's
possible to use a stopper with absorption as
option.
Fig. 25
Adjusting the Stopper
y
x
z
Содержание 4414 Series
Страница 1: ...Service Manual 4414 MADE IN GERMANY Stroke Applicator...
Страница 36: ...36 36 9 Drawings 9 2 Pneumatic drawing Type 4414 Fig 40 Pneumatics Type 4414...
Страница 37: ...37 9 Drawings 9 3 Label position Type 4414 L Fig 41 Label position 4414L...
Страница 38: ...38 38 9 Drawings 9 4 Label position Type 4414 R Fig 42 Label position 4414R...
