iNetVu New Generation Service Manual
Page 21 of 53
C-COM Satellite Systems Inc.
7.
Mount Motor using mounting pin. Install (2) locking pin clips, one on each end.
8.
Position the tension wedge below the motor mounting plate. Insert screw but do not tighten
until belt tension is set.
9.
Slide the Belt onto the EL Reducer out-put shaft. Slide the belt onto lower Pulley, making sure
the belt teeth are aligned in the grooves. The tension wedge can be moved further to the rear
providing additional slack for the belt.
10.
Proceed to tension the belt.
Motor
Mounting Pin
