BWT AQA Perla, Инструкция по установке и эксплуатации

Страница: 43 / 136

43 43 43 43 43
GB GB
GB GB
GB
Action Action Action Action Action
Refill regenerative and press the
OK button until the “low salt”
message disappears.
Refill regenerative and press the
OK button until the “low salt”
message disappears. Wait 3
hours for the brine to form and
manually start regeneration for
both softening columns, one af-
ter the other.
Establish electrical connection.
Set as described in the Start-up
section “Setting the hardness of
blended water”.
Increase inlet pressure (set
pressure reducer if necessary)
and start manual regeneration.
Mix the regenerative well by
hand in the brine cabinet.
Repeat start-up flush.
If the f If the f
If the f If the f
If the fault cannot be remedied b ault cannot be remedied b
ault cannot be remedied b ault cannot be remedied b
ault cannot be remedied by f y f
y f y f
y follo ollo
ollo ollo
ollowing these steps wing these steps
wing these steps wing these steps
wing these steps, please contact our after-sales ser , please contact our after-sales ser
, please contact our after-sales ser , please contact our after-sales ser
, please contact our after-sales service vice
vice vice
vice
depar depar depar depar department and quote the ser tment and quote the ser tment and quote the ser tment and quote the ser tment and quote the series and production n ies and production n ies and production n ies and production n ies and production number (see type plate on rear of unit). umber (see type plate on rear of unit). umber (see type plate on rear of unit). umber (see type plate on rear of unit). umber (see type plate on rear of unit).
T T
T T
Troub roub
roub roub
roubleshooting leshooting
leshooting leshooting
leshooting
F F F F Fault ault ault ault ault
A low salt level is displayed.
Unit not supplying softened or
blended water.
Unit not supplying softened wa-
ter or the flow is insufficient.
The empty indicator lights up,
although there is sufficient re-
generative.
Coloured flushing water at start-
up.
Cause Cause Cause Cause Cause
Insufficient regenerative in the
storage area (3
3 3 3 3).
No regenerative in the storage
area (3
3
3 3 3).
Power supply interrupted.
Blending adjusting spindle (V
V
V V V)
not set correctly.
Inlet pressure is too low.
A cavity has formed above the
contact switch on the sieve
base.
Abrasion particles from ex-
changer resin.