BÜTTNER ELEKTRONIK – power line pure sinewave inverter
EN
23
1 General Informations
→
At the inverter output, only devices
are allowed to be operated which are
designed for 230 V AC / 50 Hz sinewave
voltage and their power consumption
must not exceed the maximum power
of the inverter. Overload may cause
damage of the inverter, a fire or an
electrical accident.
→
In case of damage on the inverter (by
transport) or damages on wiring the
operation is not permitted.
→
Operate the device only indoor and
avoid the influence of moisture, dust
as well as direct sunlight or other heat
radiation.
→
Installation in potentially explosive
areas such as rooms with inflammable
liquids or gases is not permitted.
→ If the battery cables need to be exten-
ded, it is essential to pay attention to a
sufficient cable cross-section. Too low
cross-section may cause overheating
and cable fire. Check the wiring for
damage after installation and secure
against tensile stress with suitable
counter-measures.
→
Cables of 12V DC system voltage and
230 V AC installation are not allowed
to be placed in the same installation
channel.
→
The installation is not allowed inside ve-
hicles with connected positive battery
pole to the vehicle body!
→
It is to be ensured that there can be no
possible contact within the wiring of
the 230 V AC voltage and the 12 V DC
system voltage. Safety distances for
wiring must be strictly followed!
→
The device must be installed or stored
out of reach of children. Dispose of the
packaging after assembly to avoid risk
of danger for children !
i
i
In order to avoid unnecessary power
consumption, the inverter should only be
switched on when needed. Do not forget
to switch off the inverter with the device
switch or the remote control when not
needed anymore.
