IN U.S.A. Send To:
IN CANADA Send To:
Bushnell Performance Optics
Bushnell Performance Optics
Attn.: Repairs
Attn.: Repairs
8500 Marshall Drive
25A East Pearce Street, Unit 1
Lenexa, Kansas 66214
Richmond Hill, Ontario L4B 2M9
For products purchased outside the United States or Canada please contact your local dealer for applicable
warranty information. In Europe you may also contact Bushnell at:
BUSHNELL Performance Optics Gmbh
European Service Centre
MORSESTRASSE 4
D- 50769 KÖLN
GERMANY
Tél: +49 (0) 221 709 939 3
Fax: +49 (0) 221 709 939 8
This warranty gives you specific legal rights.
You may have other rights which vary from country to country.
©2005 Bushnell Performance Optics
Before returning for repair, consult the Trouble Shooting Table below.
trouBle sHootIng taBle
If unit does not turn on - LCD does not illuminate:
• Depress power button.
• Check and if necessary, replace battery.
If unit powers down (display goes blank when attempting to power the laser):
• The battery is either weak or low quality. Replace the battery with a good quality lithium battery.
There is no reset button to clear last range reading before ranging another target:
• The last range reading does not need to be cleared before ranging another target. Simply aim at the new
target using the LCD’s reticle, depress the power button and hold until new range reading is displayed.
If target range cannot be obtained:
• Make sure LCD is illuminated.
• Make sure that the power button is being depressed (as opposed to mode button).
• Make sure that nothing, such as your hand or finger, is blocking the objective lenses (lenses closest to the
target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
• Make sure that the targeting mode selected is the appropriate mode for that specific situation or
environment. SCAN and >150 modes have different minimum distance and sensitivity to a specific
target’s reflectivity levels.
9
8
YP SCOUT 6LIM.indd 10-11
9/6/05 11:34:15 AM
