The previously programmed INP3 value appears on the display, LED INP2 activated.
There are two methods to program input values :
Key-in method: Use
to switch between "0" (positive) and "-" (negative).
Press
to advance to the next digit to the right which goes in flash. Press
repeatedly
to increment the active digit until it takes desired value. Proceed in
the same manner with all the digits until desired value is completed on the display
with sign. Press
ENTER
to accept this value as INP3 and go next step.
Teach method: Apply signal to the meter input. Press
TEACH
to view the actual
signal value present at the input connector, LED INP2 flashes. Press
ENTER
to accept
this value as INP3 and go next step.
ESC
To exit from the programming mode
Programming of the display value for the third point, activated LED DSP2. By means of
the
and
procedure, program desired DSP3 value and press
ENTER
. The
limits of the span are -9999 and 9999 points.
a)
To validate data and advance to the next point ; press
ENTER
; or
b)
To save the programmed data in the memory and return to the run mode (the
meter is scaled by three points), press and hold down
ENTER
for 3 seconds.
ESC
To exit from the programming mode without saving changes.
MULTIFUNCTION
DIGITAL
PANEL
METER
FAST ADQUISITION
MODEL 9181
MODBUS-RTU PROTOCOL COMPATIBLE
INSTRUCTIONS MANUAL
Code: 30727148
Edition: October 2001
Valid for models with software version M-1
21
[21.2] Input 3 value
B
A
TARE
HOLD
LIMIT
MAX
MIN
DATA
DSP2
INP2
FLT
STORE
DSP1
INP1
2
1
4
3
TARE
RESET
LIMIT
MAX/MIN
ENTER
ESC
DATA
PROG
TEACH
PRG
RUN
[21.3] Display 3 value
B
A
TARE
HOLD
LIMIT
MAX
MIN
DATA
DSP2
INP2
FLT
STORE
DSP1
INP1
2
1
4
3
TARE
RESET
LIMIT
MAX/MIN
ENTER
ESC
DATA
PROG
TEACH
PRG
RUN
1 second flag indication for scaling point 3.
Multi-slope scaling sequence begins at this step..
[21.1] Point 3
B
A
TARE
HOLD
LIMIT
MAX
MIN
DATA
DSP2
INP2
FLT
STORE
DSP1
INP1
2
1
4
3
TARE
RESET
LIMIT
MAX/MIN
ENTER
ESC
DATA
PROG
TEACH
PRG
RUN
DIGIMASTER
