Burkert MS08, Руководство по эксплуатации

Страница: 75 / 84

Type MS08
Troubleshooting
75
16 TROUBLESHOOTING
16.1 Troubleshooting with messages
Messages can only be generated if the diagnostics are enabled. Refer to chapter Disable or enable the dia-
gnostics.
When a message is generated, the following actions are carried out:
▪ The symbol is displayed in the information bar.
▪ The product status indicator changes its colour and state based on the NAMUR NE 107 recommenda-
tion. Refer to chapter
Product status indicator [
}
14] .
To read the message, select . The message is displayed in the list Messages overview . See chapter
Read the generated events [ } 65] .
16.1.1 Messages [ERROR]: failure, error or malfunction
If the message displayed on your product is not explained in the Operating Instructions, contact Bürk-
ert.
16.1.1.1 Message Select sensor and restart the device
Product status symbol
Possible cause No sensor type is selected.
The wrong sensor has been selected.
What to do?
Select the sensor type. Refer to chapter Select the type of
sensor connected to the ME63 interface [
}
37]
Restart the ME63 interface.
In case of a ME63 interface exchange, use the SD card to re-
store the parameters.
16.1.1.2 Message Communication with the sensor is interrupted
Product status symbol
Possible cause The ME63 interface could not access the sensor.
The ethernet communication is broken.
What to do? Check if the cable wiring is correct, restart the device.
Check the ethernet communication activities. The led link/act is
blinking when there is activities. Refer to chapter
Display ele-
ments [
}
14] .
Check if the sensor is powered.