Burkert MS08, Руководство по эксплуатации

Страница: 55 / 84

Type MS08
General Settings - Parameter
55
Make sure that the login user level is Installer . Refer to chapter Available login user levels [ } 35] .
Go to device SAC254 Sensor > function General settings > tab Parameter .
Select büS > Advanced > Baud rate .
Select the transmission speed from the drop-down list.
The transmission speed of the product is set.
Restart the product to take the transmission speed into account.
12.7 Address of a product connected to büS
If the product is connected to büS, büS automatically addresses the product.
12.8 Change the address of the product connected to a
CANopen fieldbus
To attribute an available address to the product, do the following procedure:
Make sure that the login user level is Installer . Refer to chapter Available login user levels [
}
35] .
Go to device SAC254 Sensor > function General settings > tab Parameter .
Select büS > Advanced > Fixed CANopen address (Node ID) .
Enter an available address in the parameter Fixed CANopen address (Node ID) .
To activate automatic addressing of the CANopen address, enter 0 in the parameter Fixed CANopen
address (Node ID) .
Validate with Apply .
The address of the product is set.
Restart the product to take the set address into account.
12.9 Read the actually used CANopen address (Node
ID)
This value is read-only.
Make sure that the login user level is Installer . Refer to chapter Available login user levels [
}
35] .
Go to device SAC254 Sensor > function General settings > tab Parameter .
Select büS > Advanced .
Read the value of the parameter CANopen address (Node ID) .
12.10 Set the digital communication for büS or for a
CANopen fieldbus
By default, the operating mode of the digital communication is set to büS and the measured process data
(PDOs, process data objects) is sent on a connected fieldbus.
The other operating modes of the digital communication are CANopen or Standalone .
If the product is connected to büS or to a CANopen fieldbus, do the following to change the operating
mode of the digital communication:
Make sure that the login user level is Installer . Refer to chapter Available login user levels [
}
35] .
Go to device SAC254 Sensor > function General settings > tab Parameter .