Bull NovaScale R410 E1, Руководство пользователя

Страница: 136 / 319

User Guide
136
www.bull.com
Installing or Removing a 5.25-inch Device
This section of the chapter describes how to add and remove 5.25-inch devices. You
can install a CD-ROM, DVD-ROM, COMBO DVD-ROM CD-RW or DVD+R9
Drive, tape backup unit, or other 5-25 inch devices in the additional 5.25-inch bay. See
the installation instructions included with those items for specific installation
information.
Adding a 5.25-inch Device
1. Remove the right side door. See “Removing the Right Side Door” on page 133.
2. Remove the front panel. See “Removing the Front Panel” on page 135.
3. From the inside of the chassis, push on the desired slot cache with your left
hand and hold it with your right hand outside the chassis.
4. Pivot the cache until it gets released from the frame.
Note: The two tabs that hold the cache actually break: this
is normal.
5. Take two slide rails marked as “CD-ROM”. Slide rails come with the system in
a plastic bag.
6. Attach the slide rails to the upper holes on both side of the 5.25-inch device.
Figure 87: Attaching the Slide Rails
7. Slide in the 5.25-inch device until it clicks into place.
8. Connect the cable(s) to the drive. See “Cabling SATA Devices” on page 128.
9. Replace the front panel. See “Replacing the Front Panel” on page 135.
10. Replace the right side door. See “Replacing the Right Side Door” on page 134.
Note: Modify the BIOS Setup program to recognise the
additional device. For additional information, refer to “BIOS
Setup Utility” on page 282 .