Buhnen HB 5010, Перевод оригинального руководства по эксплуатации

Страница: 39 / 142

Programming
31
6.3.3.7 Optimization
_ Tank
Pump
Hose1
Gun1
Figure 6.3.3.6/1: “Optimization”
This menu item enables the automatic determination and setting of the (PID) controller
parameter for the components
• Tank
• Pump
• Hose 1
• Gun 1
• Hose 2
• Gun 2
Always start the optimization runs from the cold condition, as a heating up phase must be
run through to determine the parameters.
To start an optimization run, select the desired component with “Up/Down Arrrow” and
press “Enter.” During the optimization run, a rotating cursor will appear next to the corre-
sponding component in the display.
Since the temperatures of the individual components interact, the determined PID param-
eters of a component can be easily differentiated during several successive optimization
runs.
The optimization runs can be cancelled at any time using “ESC”.
The following table offers an overview of the approximate times needed for optimization
runs:
Component Required time
Tank approx. 30 min
Pump approx. 30 min
Hoses approx. 10 min
Manual application unit approx. 10 min