Buhnen HB 5010, Перевод оригинального руководства по эксплуатации

Страница: 21 / 142

Overview of HB 5010
13
Enter
This key confirms the entry of a value or the selection of a menu item (using the up/down
arrow).
Standby
By pressing this key, the tank system in manual operation is switched to active standby
mode. The temperature of the hot melt material is decreased by a previously programmed
value (factory setting: 40 °C) in order to protect the hot melt material (e.g. during work
breaks). During time mode, the system will switch into manual mode after this key has
been pressed.
Info
The current actual or target values of all components are displayed when this key is
pressed. Use the “Up arrow/Down arrow” keys to switch between the actual and target
values. After a time, the display will switch back into normal view.
Act: Tank : 54
0
C
Pump : 21
0
C
H1:21
0
C G1: 21
0
C
H2:OFF G2:OFF
Figure 3.3.2/1: Display after pressing the “Info” key (Example)
Menu
The menu key switches the control unit to programming mode. The programming menu is
displayed. A blinking spot indicates the position of the cursor. Maneuver within the menu
using the “Up/Down arrow,“ „Entry,“ and „Cancel“ keys.
1_SingleOnOff
2 Mode
3 Language/Sprache
4 Password
Figure 3.3.2/1: Display after pressing the “Menu” key
On/Off
This key turns the tank system on and off (per software).
After turning off with activated timer, the timer remains in operation and will turn on the
tank system at the next programmed time.
The following security prompt is displayed first:
Tool
stops
Confirm with Enter
Figure 3.3.2/1: Security prompt before turning off