Buell 2007 ULYSSES, Руководство по обслуживанию, Страница: 628 / 647

2007 Buell Ulysses: Electrical 7-65
HOME
HORN 7.21
REMOVAL
1. Remove seat. See 2.45 SEAT.
1
WARNING
1
WARNING
To prevent accidental vehicle start-up, which could
cause death or serious injury, disconnect negative (-)
battery cable before proceeding. (00048a)
2. Disconnect negative battery cable.
3. Remove windshield and windscreen. See 2.44 WIND-
SHIELD AND WINDSCREEN .
4. See Figure 7-75. Remove fastener (3).
5. Remove horn (1) from fairing support bracket (4).
6. Detach Y/BK power wire and BK ground wire from termi-
nal clips on horn.
INSTALLATION
1. See Figure 7-75. Connect Y/BK power wire and BK
ground wire to terminal clips on horn.
2. Attach horn (1) to fairing support bracket (4) using fas-
tener (3). Tighten to 36-60 in-lbs (4.0-6.7 Nm).
3. Install negative battery cable.
4. Check horn operation. If horn does not sound or fails to
function satisfactorily, see
TROUBLESHOOTING .
a. Turn ignition key switch ON.
b. Press horn switch to activate horn.
c. Turn ignition key switch OFF.
5. Install windshield and windscreen. See 2.44 WIND-
SHIELD AND WINDSCREEN
1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
6. Install seat. See 2.45 SEAT.
Figure 7-75. Horn Assembly
Figure 7-76. Left Handlebar Switch Connection
1. Horn
2. Horn connectors [122]
3. Horn fastener
4. Support bracket
11930b
1
3
4
2
2
8
7
6
5
4
3
1
2
1
b1103a7x
Clutch Switch
Left Handlebar Switch
Y/BK
To headlight
BE/W
Y/BK
V/BN
Light power
High beam
Horn
From flasher
Left turn
Right turn
Horn power
To interlock circuit
To ground
Y
W W
Y
V
O
V
O
BN BN
BE BE
BK
TN/LTGN
[24B] [24A]
[95A] [95B]
O