Buell 2007 ULYSSES, Руководство по обслуживанию, Страница: 475 / 647

4-126 2007 Buell Ulysses: Fuel System
HOME
INSTALLATION
1. See Figure 4-112. Hold base plate above mounting posi-
tion.
2. Insert IAT sensor into grommet on baseplate from under-
side.
NOTES
● A small amount of soapy water applied to the inside
diameter of grommet will make breather hose installation
easier.
● In next step, be sure breather hoses do not extend past
Intake air temperature sensor tower. If hoses extend past
tower, damage to sensor may occur.
3. Insert longer breather hose into right baseplate grommet
from underside.
4. Attach shorter breather hose onto crankcase breather
located on top of rear cylinder.
5. Carefully lower baseplate into mounting position. Ensure
rubber sealing ring on velocity stack completely engages
baseplate. Baseplate should be sandwiched between
upper and lower rubber sealing rings.
6. See Figure 4-113. Install baseplate (11) to frame with
four fasteners and washers (10). Tighten fasteners to 84-
120 in-lbs (9.5-13.6 Nm).
7. Position air cleaner filter on baseplate.
8. Install air cleaner cover to base plate and latch six
latches to secure.
9. If interactive exhaust actuator was removed, install at this
time and tighten fasteners to 36-40 in-lbs (4-4.5 Nm).
10. Route vent hose through groove on air cleaner cover to
vent valve.
NOTE
See 1.16 INTERACTIVE EXHAUST CABLE .
11. Install intake cover assembly. See 2.39 INTAKE COVER
ASSEMBLY .
1
WARNING
1
WARNING
After installing seat, pull upward on front of seat to be
sure it is in locked position. While riding, a loose seat can
shift causing loss of control, which could result in death
or serious injury. (00070a)
12. Install seat. See 2.45 SEAT .
Figure 4-112. Baseplate (All Models)
11215
1. Fasteners
2. Intake air temperature sensor (IAT)
3. Gasket
4. Baseplate
5. Breather hoses
6. Velocity stack
7. Velocity stack sealing ring
1
1
7
2
4
3
1
6
5