Buell 2007 ULYSSES, Руководство по обслуживанию, Страница: 143 / 647

2-14 2007 Buell Ulysses: Chassis
HOME
8. See Figure 2-14. Remove the BACKING PLATE (Part
No. B-43993-11) from the long forcing screw. Reinstall
the Backing Plate onto the forcing screw, with the smaller
diameter toward the hex-head.
9. Insert the forcing screw through the wheel hub on the
opposite side of the wheel.
10. See Figure 2-15. Install the spacer.
11. See Figure 2-16. Insert a new wheel bearing (1)
squarely into the hub, with the lettered side facing out
(away from the wheel).
12. Slide the FRONT BEARING INSTALLER (Part No. B-
43993-9) (2) onto the forcing screw (3), with the smaller
diameter toward the bearing bore.
13. Install a washer (4), Nice bearing (5) and nut (6) onto the
forcing screw (3).
NOTE
See Figure 2-15. Center the spacer (2) while installing the
wheel bearing. Failure to center the spacer could cause the
bearing not to pull in straight.
14. See Figure 2-16. While holding the forcing screw (3),
tighten the nut (6) until the bearing contacts the spacer.
15. Remove the nut, bearing, washer, FRONT BEARING
INSTALLER (Part No. B-43993-10) and forcing screw.
16. Install the wheel. See INSTALLATION under 2.5 FRONT
WHEEL.
Figure 2-14. Insert Forcing Screw and Backing Plate
Figure 2-15. Install the Spacer
i04283
1. Forcing screw
2. Backing plate
1
2
i04286
1. Forcing screw
2. Spacer
2
1
Figure 2-16. Install the Bearing
i04287
1. Wheel bearing
2. Front Wheel Bearing Installer (B-43993-9)
3. Forcing screw
4. Washer
5. Nice bearing
6. Nut
5
1
6
3
4
2