Bticino MH08CT/GB, Техническое руководство

Страница: 68 / 156

66
my Home - control
front view
LED
programming/
reset pushbutton
receiving lens
rear view
room number
receiving the
control
channel
selection
operating
mode
selector switch to
enable
programming
The receiver can add the remote control by means of infrared ray controls
(item 4482/7 – 4482/16) to the manual control or replace the manual
control by the remote control.
Controls intended for 1-relay actuators for single loads and 2-relay actuators
for double loads (rolling shutter motor etc.), scenario managements, Sound system and Video door entry system (only in self-learning mode) can be
associated to the remote control pushbuttons On the front the device has,
as well as the IR receiving lens, a programming pushbutton and a LED to
indicate the programming phase and reception of the IR signal sent by the
remote control.
Remote controls
item 4482/7
7 channels item 4482/16
16 channels
The IR receiver can be set up for 4 different operating modes depending on
the configuration of positions A, PL 1 to 4 and M:
PL1
PL2
PL3
PL4
Correspondence between remote control pushbuttons and loads controlled
(mode A)
table
Mode
M Functions which can be performed
A 1 to 4 Repeating of 4 generic controls (ON/OFF, UP/DOWN) with the 4 remote control keys.
Remote The receiver saves the controls required in the installation phase,
control by inserting configurators in positions A, PL 1 to 4 and M.
Changing the pre-set functions involves the reconfiguration of the IR receiver.
B CEN Activation of scenarios managed by the scenario programmer item MH200
Advanced scenarios
C none Repeating of generic controls (ON/OFF, UP/DOWN) with the remote control keys.
Remote In this case the receiver saves the controls with a self-learning procedure.
self-learning The customer can change the succession and the controls saved to be recalled
with the remote control at any time.
D 6 Management with the remote control of a maximum of 16 recorded scenarios in the scenario module item F420.
Scenario module
control
E 9 See “Sound system” Technical guide.
Sound system
ir receiver item Hc/Hs4654,
item l/n/nt4654n and item Am5834