Bticino MH08CT/GB, Техническое руководство

Страница: 65 / 156

MY HOME cOntROL technical GUiDe
63
configurAtion
Operating modes for scenario management
Setting configurator 6 in the SPE socket, the touch Control can call, program
and cancel any of the 16 scenarios contained in a Scenario Module item
F420. The scenario number can be selected using configurators 1-9 in
table 4
M M2 Scenario number
0 1 1
0 2 2
... ... ...
1 6 16
A - PL
Address (2 digits) of the Scenario Module to be controlled
Programming a scenario
1) the Scenario Module must be enabled in order to execute the
programming process;
2) put your hand near the detector zone of the control (the LEDs will switch
on at their maximum intensity) and keep it in position. The intensity of
the LEDs will decrease to their lowest level after 3 seconds; now move
your hand away from the control;
3) the LEDs will begin to flash with a very low frequency, hence indicating
the activation of the programming mode;
4) set the scenario using the controls and/or actuators;
5) put your hand briefly near the control to exit the programming mode; the
LEDs will stop flashing and will return to their lowest level of intensity.
cancelling a scenario
1) the Scenario Module must be enabled in order to execute the
programming process;
2) put your hand near the detector zone of the control (the LEDs will switch
on at their maximum intensity) and keep it in position. The intensity of the
LEDs will decrease to their lowest level after 3 seconds; keep your hand in
position for about another 5 seconds;
3) the LEDs will start flashing with a high frequency, thus indicating that the
scenario has been cancelled; they will then return to their lowest level of
intensity.
NOtE:
To cancel all scenarios of the module, use the reset key directly on the
scenario module.
positions M and M2, as in the following table. The address of the Scenario
Module to control must be indicated in positions A and PL.
A = 1 to 9 room receiving the command
PF/PL = 0 to 9 address of the amplifier to be controlled
M = 0 follow me mode
1 to 4address of the first source to activate
SPE = 8 Sound system mode
or
A = AMB room configuration
PF/PL = 0 to 9 room to control
M = 0 follow me mode
1 to 4address of the first source to activate
SPE = 8 Sound system mode
or
A = GEN this command activates all the amplifiers in the home
PF/PL = /
M = 0 follow me mode
1 to 4address of the first source to activate
SPE = 8 Sound system mode
modes of operAtion for sound system