Bruno SRE-1550 Electra-Ride II, Руководство по установке

Страница: 38 / 76

©2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
SRE-1550 UL 06-18-2004
38
CONVERSION TO RIGHT-HAND INSTALLATION- COMMERCIAL UNIT
As shipped from the factory, the Elevator is set up for left-hand installation (as viewed from the bottom of the
stairs.) Should the installation require a right-hand installation, perform the
following operations:
Turn the on / off circuit breaker on the rear of carriage to `OFF'.
Remove left carriage cover.
Set the Installation DIP Switch (S2) to the `RH' position.
Set the No. 1 DIP Switch on the 4-Ganged Dip Switch (S1) to the `OFF' position.
Check that the power Switch (S3) is turned `ON' .
Unplug the motor leads and reverse the connections.
Turn the circuit breaker switch to the “ON” position.
Replace the carriage cover.
CHANGING CONTROLS FROM RIGHT TO LEFT ARMREST
SET THE
INSTALLATION DIP
SWITCH (S2) FROM
`LH' TO `RH'
POSITION
SET NO. 1 SWITCH OF
(S1)
TO THE `OFF'
POSITION
POWER DIP
SWITCH (S3)
1. Remove the switch housing weldment by removing the Torx head machine screw under
the arm. The trim holding the harness on the backside of the arm slides off.
2. To disconnect the harness under the seat , remove the seat hinge nut.
3. Slide the harness cable guide off.
4. Reinstall the seat hinge nut.
5. Remove the 2 screws from the swivel switch cover, then remove the cover.
6. Unplug the switch harness, and remove the grommet.
7. Slide the grommet onto the other side of the swivel switch cover, and reconnect the
harness.
8. Reassemble the cover using the 2 screws.
9. Remove the seat hinge nut, and install the harness guide on the opposite side.
10. Fasten the switch housing on the left arm. Slide the trim over the harness on the backside
of the arm.
REVERSING CONNECTIONS
CIRCUIT BOARD
INSTALLATION