Bruno SRE-1550 Electra-Ride II, Руководство по установке

Страница: 17 / 76

©2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
17
SRE-1550 UL 06-18-2004
*INSTALL FOOT CLAMPS AT LEAST 1-1/2” FROM WALL. PROVIDE ADDITIONAL
CLEARANCE IF SEAT NEEDS TO SWIVEL AGAINST WALL. BEFORE SECURING ALL
CLAMPS, RUN CARRIAGE ASSEMBLY UP AND DOWN STAIRWAY TO CHECK SEAT
CLEARANCE OVER THE ENTIRE TRAVEL LENGTH.
RAIL
RAIL MOUNTING FOOT
CLAMP ASSEMBLY
1/2" TO 1"
ABOVE
NOSING
[ ] Install rail mounting foot clamps in the placement pattern as shown below. Be
sure to leave a minimum space of 1-1/2" from the wall.
POSITIONING FOOT CLAMP ASSEMBLIES-Residential and Commercial Units
*bottom landing
*first tread up from bottom landing
*top landing
*first tread down from top landing
*closest tread above and below rail joint(s)
*minimum of every third tread over the remainder of the staircase.
NOTE: IF TOP OR BOTTOM CLAMP IS OMITTED BECAUSE THE LANDING IS CEMENT OR
CERAMIC TILE , OR IN THE EVENT THAT THE OWNER WISHES NOT TO DRILL HOLES IN THE
LANDING, A SET OF CLAMPS SHOULD BE ADDED ON THE SECOND-TO- LAST STEP AND AT
THE TOP OF STAIRWAY.
[ ] For ease of installation, finger tighten all clamps to rail. The clamp assembly should
be positioned so the nut is closest to the wall.
[ ] Slide top and bottom clamps down until firmly seated on step. When installing on
carpeted stairs, use a rubber mallet on the clamps to compress carpet and cushion
before anchoring to steps.
[ ] Securely install one screw near the wall on the top and bottom of foot of clamp
assemblies. This will enable the installer to change the position of the rail if
necessary and prevent drilling excess holes.
[ ] Make sure to use the measurements indicated below as a guide for positioning the
clamp assemblies.
*SEE NOTE BELOW
INSTALLATION