Bruno SRE-1550 Electra-Ride II, Руководство по установке

Страница: 37 / 76

©2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
37
SRE-1550 UL 06-18-2004
Chirp .25 Seconds
Short Beep .5 Seconds
Long Beep 1.5 Seconds
Pause 1 Second
CHANGING THE PCB DIAGNOSTIC MODE
* Turn the Circuit Breaker on the carriage to `OFF'.
* Remove Left carriage cover.
* Turn the Power DIP Switch (SW3) to the `OFF' position.
* Unit is shipped is Multi-User Diagnostic Mode.
Changes are made on (S1) 4 Ganged DIP Switch -
Number 3 and Number 4 Positions.
4 GANGED DIP SWITCH (SW1)
DIAGNOSTIC MODE DIP SWITCH POSITION
#3 #4
Multi-User OFF OFF
Single-User OFF ON
Quiet ON OFF
Battery Warning Only ON ON
OTHER CIRCUIT BOARD FEATURES
INSTALLATION
CIRCUIT BOARD DIAGNOSTICS
COMMERCIAL UNIT
NOTICE:
Before touching anything inside the carriage assembly,
ground yourself by touching an unpainted metal
surface on the unit such as an exposed bolt,
or one of the mounting screws on the electrical panel.
While you work, periodically touch an unpainted metal
surface to dissipate any static electricity that could
harm internal components.
Also located on S1 DIP Switch are switch #1 Installation and #2 Coast Delay. Refer to Re-
versing Operation instructions for changing Switch # 1. The coast delay option (Switch #2 on
S1) has been provided in cases of interference which may cause intermittent operation. The
normal setting is 600 mS seconds of coast, should the unit lose the remote call/send signal,
this can be increased to 900mS seconds by moving switch # 2 on S1 to the `ON' position.