Bruno SRE-1550 Electra-Ride II, Руководство по установке

Страница: 15 / 76

©2004,1996 BRUNO INDEPENDENT LIVING AIDS, INC.®
15
SRE-1550 UL 06-18-2004
IMPORTANT NOTE!
Under no circumstances should a rail section be cut shorter than
18” (46 cm).
There must be at least (2) clamps on a short rail section (1 at the
rail joint and 1 at the rail end). Cutting a rail shorter than 18” (46
cm) would not allow enough room for the (2) necessary clamps.
Example:
After measuring the staircase, you determine you need 9 feet of
rail. With your (2) 8-foot sections you decide to use (1) 8-foot sec-
tion and cut the remaining (1) foot from the second 8-foot section.
Doing this could yield a rail piece with insufficient weld.
Instead, Bruno recommends cutting at least one foot off one of the
8-foot sections (leaving 7 feet of rail) and then cutting 2 feet from
the second 8-foot section. You will have a (1) 7-foot section and
(1) 2-foot section, both of which are long enough to be properly
mounted (2 clamps minimum per short rail).
INSTALLATION
CUTTING THE RAIL-Residential and Commercial Units
NEVER CUT OFF THE JOINT END!
The M6 bolts securing the gear rack must remain intact.
Cut off the end with the pre-drilled charge contact mounting holes.
Then, using the provided template, redrill (2) holes on each end of the rail.
1. Use a metal-cutting power saw or manual hacksaw to cut
the rail to length. Cut off the end of the rail to be located at
the top of the stairway .
2. Use a file or other appropriate tool to deburr the cut end
of the rail. Soften any sharp edges which might abrade
the insulation of the wiring to be routed to the bumper at
the end of the rail.
3. Use a C-clamp to hold the upper bumper bracket in place
in the cut end of the rail.
4. Use the holes in the bumper bracket as guides to drill
mounting holes. Use an O-size (8.03 mm/.316") drill bit
in the rail.
USE “O” SIZE DRILL
BIT (8.03mm/.316")