Brother XL-2121, Руководство по эксплуатации

Страница: 14 / 63

13
1
Changing the Presser Foot
You will have to change the presser foot depending
on what you want to sew and how.
■
Snap-On Type
1
Raise the needle to its highest position by
turning the balance wheel toward you
(counterclockwise) and raise the presser foot
lever.
2
Release the foot by raising the lever at the
back of the holder.
1 Presser Foot
2 Shank
3
Put a different presser foot on the needle plate
so that the bar on the presser foot is in line
with the slot on the shank.
4
Lower the presser foot lever and fix the
presser foot onto the shank. If the presser foot
is in the correct place, the bar should snap in.
■
Presser foot installation orientation
●
Always turn off the power before you
change the presser foot. If you leave the
power on and step on the controller, the
machine will start and you may be
injured.
●
Always use the correct presser foot for
the stitch pattern you have chosen. If you
use the wrong presser foot, the needle
may strike the presser foot and bend or
break, and may cause injury.
●
Only use presser feet that have been
designed to be used with this machine.
Using other any presser feet may cause
an accident or injury.
CAUTION
1
2
●
If the presser foot is not installed with the
correct orientation, the needle may strike
the presser foot, which may bend or
break the needle and cause injury.
CAUTION