Brother HL- SERIES, Техническое справочное руководство, Страница: 260 / 392

Revision C 16/01/96
Chapter 7 "Bar Codes Control" - 2
Bar Code Control
The printer can print bar codes in the HP LaserJet 4, Diablo, EPSON FX-850, and IBM Proprinter
XL emulation modes.
P
RINT
B
AR
C
ODES OR
E
XPANDED
C
HARACTERS
ESC i n ... n \ (27)(105)n ... n (92) <1Bh><69h>n ... n <5Ch>
Creates bar codes or expanded characters according to the segment of parameters “n ... n”. For
further information about the parameters, see the following “Definition of Parameters.” This
command must end with the “ \ ” code (5CH).
D
EFINITION OF
P
ARAMETERS
This bar code command can have the following parameters in the parameter segment (n ... n).
Parameters are effective only within the single command sequence using the syntax ESC i
n ...
n \. They do not take effect in any subsequent bar code commands. If any parameters are not
specified, they take the default settings. The last parameter must be the bar code data start
identifier (“b” or “B”) or the expanded character data start identifier (“l” or “L”). Other
parameters can be specified in any sequence. The prefix of each parameter can be either a lower-
case or upper-case character, - for example, “t0” or “T0”, “s3” or “S3”, etc.
(1) Bar Code Mode
n = “t0” or “T0” CODE 39 (default)
n = “t1” or “T1” Interleaved 2 of 5
n = “t3” or “T3” FIM (US-Post Net)
n = “t4” or “T4” Post Net (US-Post Net)
n = “t5” or “T5” EAN 8, EAN 13, or UPC A
n = “t6” or “T6” UPC E
n = “t9” or “T9” Codabar
n = “t12” or “T12” Code 128 set A
n = “t13” or “T13” Code 128 set B
n = “t14” or “T14” Code 128 set C
n = “t130” or “T130” ISBN (EAN)
n = “t131” or “T131” ISBN (UPC-E)
n = "t132" or "T132" EAN 128 set A
n = "t133" or "T133" EAN 128 set B
n = "t134" or "T134" EAN 128 set C
This parameter selects the bar code mode as above. When n is “t5” or “T5”, the bar code
mode (EAN 8, EAN 13, or UPC A) varies according to the number of characters in the data.