242
Troubleshooting
Probable Cause
Remedy
Is any water content attached to the pretreatment
roller after the pretreatment is fixated?
With reference to "6-3-4. Fixation of pretreatment >>P.141",
prevent water content from being attached to the roller after the
pretreatment is fixated.
Is there any lint, yarn waste, dust, etc. that are
attached to the surface of pretreatment roller? (This
applies to the case where the pretreatment roller is
used.)
With reference to "6-3-3. Application of pretreatment >>P.135",
clean the surface of the pretreatment roller.
Did you shake the pretreatment after its dilution?
With reference to "6-3-2. Dilution of pretreatment >>P.133", shake
the pretreatment sufficiently.
Is the [Low Temperature Mode] set to [Disable]?
With reference to "8-5. Print Operation Settings Under Low
Temperature >>P.227", change the setting to [Enable(Normal)].
Has the pretreatment been fixated insufficiently?
With reference to "6-3-4. Fixation of pretreatment >>P.141",
check on an actual temperature of the heat press and its pressure
during the fixation stage.
Always keeping the lower iron (where media is placed) of the heat
press at heated temperature with a heating source may solve this
problem.
Whiteness of print result is insufficient
Probable Cause
Remedy
Has the pretreatment been applied insufficiently?
With reference to "6-3-3. Application of pretreatment >>P.135",
apply a proper amount of pretreatment.
Has the pretreatment been fixated insufficiently?
With reference to "6-3-4. Fixation of pretreatment >>P.141",
check on an actual temperature of the heat press and its pressure
during the fixation stage.
Is there any nozzle that does not eject ink-jet
droplets?
Press
on the operation panel, or perform the head cleaning
by selecting [Head Cleaning] from the menu.
If this problem is still not remedied, follow the instructions of
"9-2-1. Recovery action to be taken for such a nozzle that is
unable to eject ink-jet droplets >>P.245".
Is the white ink circulated insufficiently?
From the menu, select [Maintenance] > [White Ink Circulation] to
circulate the white ink properly.
Do you perform white ink refilling?
With reference to "6-2-3. Daily agitation of the white ink >>P.127",
perform white ink refilling.
Is the white ink stirred insufficiently?
In the event that the white ink remains accumulated in the bottom
of the ink pouch, shake the pouch 100 times and additionally
shake it until the ink is stirred well.
Also, when the remaining ink level becomes approximately 5.9 in.
(15 cm), shake the cartridge with its cover open and with the edge
of the ink pouch slightly winded.
Is the [Low Temperature Mode] set to [Disable]?
With reference to "8-5. Print Operation Settings Under Low
Temperature >>P.227", change the setting to [Enable(Normal)].
Is the dilution rate of the pretreatment correct?
With reference to "6-3-2. Dilution of pretreatment >>P.133",
correctly dilute the pretreatment.
Содержание GTX-4
Страница 145: ...145 Basic printing procedures 5 Tighten the platen fixing lever X0101 Platen fixing lever ...
Страница 156: ...156 Basic printing procedures When Color Ink Only is selected Details ...
Страница 261: ...261 Troubleshooting X0181 Cleaning conditions Pre cleaning state Post cleaning state ...
