10h–1Fh Register Map Detailed Description
BCM5718 Programmer’s Guide
Broadcom
®
January 29, 2016 • 5718-PG108-R
Page 520
19h: Auxiliary Status Summary (Copper Side Only)
6
RGMII RXER MODE
RW
1 = mux rx_er with rx_dv for RGMII mode
0 = mux crs with rx_dv for RGMII mode
1
5
RGMII OUT-OF-BAND
STATUS DISABLE
RW
1 = send regular rx data during IPG
0 = send out-of-band status info in RGMII mode
1
4
WIRESPEED ENABLE
RW
1 = enable wirespeed mode
0 = normal operation
Note: Can be set only if gphy port
wirespd_enable = 1.
0
3
MDIO ALL PHY
SELECT
RW
1 = all phy selected during MDIO writes when
the phy address = “00000”
0 = normal operation
0
2:0
SHADOW REGISTER
SELECTOR
(REFERENCE ONLY)
RW
Writes to the selected shadow register are done
on a single cycle (no setup required).
Reads are selected by first writing to register
18h, shadow 7, bits 14:12.
111
Bit 7 affects mode of operation. Please consult 0.5 for further information.
Bit
Name
RW
Description
Default
15
AUTO-NEGOTIATION
COMPLETE
RO
1 = auto-negotiation complete
0 = auto-negotiation in progress
0
14
AUTO-NEGOTIATION
COMPLETE ACK
RO
LH
1 = entered auto-neg “link good check” state
0 = state not entered since last read
0
13
AUTO-NEGOTIATION
ACK DETECT
RO
LH
1 = entered auto-neg “acknowledge detect”
state
0 = state not entered since last read
0
12
AUTO-NEGOTIATION
ABILITY DETECT
RO
LH
1 = entered auto-neg “ability detect” state
0 = state not entered since last read
0
11
AUTO-NEGOTIATION
NEXT PAGE WAIT
RO
LH
1 = entered auto-neg “next page wait” state
0 = state not entered since last read
0
10:8 AUTO-NEGOTIATION
HCD (CURRENT OPERAT
ING SPEED AND DUPLEX
MODE)
RO
111 = 1000BASE-T full duplex*
110 = 1000BASE-T half duplex*
101 = 100BASE-TX full duplex*
100 = 100BASE-T4
011 = 100BASE-TX half duplex*
010 = 10BASE-T full duplex*
001 = 10BASE-T half duplex*
000 = no highest common denominator (when
auto-neg complete = 1) or auto-negotiation not
complete (when auto-neg complete = 0)
000
7
PARALLEL DETECTION
FAULT
RO
LH
1 = parallel detection fault
0 = no parallel detection fault
0
Bit
Name
RW
Description
Default