BRAYER BR1105, Инструкция по эксплуатации

Страница: 13 / 62

13 EN
will light up, and the illumination of buttons (18,
19, 20) will be flashing. When the buttons (18, 19,
20) illumination will glow constantly, it means that
preheating is finished.
9. Press the button (20) « », depending on the
preset water supply time, press the button (20) «
» once or twice, fill a cup of approximately 100
ml capacity with water (it is necessary to remove
water from the boiler and fill it with citric acid
solution), if necessary, switch the water supply off
by pressing the button (20) « » again. Pour the
liquid out from the cup.
10. Switch the water supply on by pressing the button
(20) « » and fill a cup of about 100 ml capacity,
press the button (20) « » again to switch the
water supply off and pour the liquid out of the cup.
11. After a while repeat the procedure described in
the paragraph 10 and fill the cup of about 100 ml
capacity again.
12. Press the steam supply button (19) « ». Put a
suitable bowl under the tip (12) and slightly open
the steam supply by turning the knob (9) « »
counterclockwise. Carefully turn the knob (9) «
» to the maximal steam release position,
release the steam for about 1 minute, then close
the steam by turning the knob (9) « »
clockwise until bumping «•».
13. Switch the coffee maker off by pressing the on/off
button (17) « »,. Wait for 10-15 minutes.
Note: some water or steam may appear from the filter
holder (5), it is normal.
REMOVING MINERAL SCALE
For effective operation of the coffee maker we
recommend removing scale every 2-3 months and when
using “hard” water more often.
1. Make sure that the power plug is not inserted into
the mains socket.
2. Make sure that the steam supply is closed. To
do this turn the knob (9) « » clockwise until
bumping «•».
3. Make citric acid solution: 2 teaspoons of acid to 1
litre of water and pour the solution into the water
tank (15). Install the tank (15) back to its place.
4. Install the coffee filter (6) into the holder (5) having
preliminary matched the ledge on the filter (6) with
the groove on the holder (5) and turn the filter (6)
counter/clockwise to fix the filter. Do not put ground
coffee into the filter (6).
5. Install the filter holder (5) into the coffee maker. The
holder (5) ledges should match the grooves on the
boiler «INSERT», after that turn the filter holder
handle (4) to the right until bumping «LOCK».
6. Place a suitable cup on the grid (2).
7. Insert the power plug into the mains socket.
8. Switch the espresso machine on by pressing the
on/off button (17) « », the button (17) illumination