BRAYER BR1105, Инструкция по эксплуатации

Страница: 7 / 62

7 EN
19, 20) will be flashing. When the buttons (18, 19,
20) illumination will glow constantly, it means that
preheating is finished.
Notes:
- when switching the unit for the first time, the
buttons (18, 19, 20) illumination will be flashing
quickly, because the boiler is empty. Press the
two cups button (20) « », the pump will be
switched on and start injecting water into the
boiler, the buttons (18, 19, 20) illumination will stop
flashing and start glowing constantly;
- the first switching on of the pump may be
accompanied by an uncharacteristic sound, this
is a normal. After filling the boiler with water, the
sound of the pump will return to normal.
• Wait until the buttons (18, 19, 20) illumination glows
constantly, then switch the water supply on by
pressing the button (20) « », the pump will switch
on for 25 seconds, pour the water out from the cup
and press the button (20) again « » to switch the
water supply on again. After switching the pump off,
pour the water out from the cup.
• Repeat this procedure several times, the boiler will
be clean after that.
• To switch the espresso machine off, press the on/
off button (17) «
», the buttons (17, 18, 19, 20)
illumination will go out.
AUTO SWITCH OFF FUNCTION
• If no actions were performed during 25 minutes
after switching on, the coffee maker will switch off
automatically.
HOW TO MAKE A GOOD ESPRESSO
• Use ground coffee for espresso coffee makers.
• Slightly tamp the ground coffee in the filter (6), you
can do it with the back side of the measuring spoon
(17).
• Coffee strength depends on the quality and grinding
degree of coffee beans. If coffee is pouring out too
long, this means the coffee powder is too fine or it is
tamped too strongly.
PREHEATING
• To make a cup of hot espresso, it is recommended to
preliminary heat up the coffee filter (6) and the filter
ATTENTION!
• Do not remove the filter holder (5) during espresso
machine operation.
• Do not remove the filter holder (5) immediately
after preparing coffee as there is redundant water
and steam pressure inside the filter (5), let the
coffee maker cool down completely.
• To remove the filter holder (5) turn the handle (4) to
the left «INSERT» and remove the filter holder (5).