BraunAbility EntervanII, Руководство по эксплуатации для владельца

Страница: 12 / 65

Page 10
Pre-Operation Notes and Details
Passenger Door Outside Key Entry
Control Switches (continued)
An outside key entry is incorpo-
rated in the passenger side front
door lock. The outside key entry
activates the same functions as
the interior-mounted yellow
OPEN/CLOSE switches and the
remote control transmitter OPEN
and CLOSE switches. The
vehicle OEM door key activates
the outside key entry system as
well as operating the passenger
door lock. See your Chrysler
owner's manual for details
regarding door locks.
OPEN: Insert the key and turn it
clockwise (toward front of vehicle)
to open the automatic door and
unfold (lower) the ramp.
Note:
Turning the key clockwise also
activates the “kneeling” feature to
lower the vehicle if the red dash-
mounted KNEEL switch is in the
YES (up) position.
CLOSE: Insert the key and turn it
counterclockwise (toward rear of
vehicle) to fold (raise) the ramp
and close the automatic door.
Note: Turning the key counter-
clockwise also activates the
“kneeling” feature to raise the
vehicle if the red dash-mounted
KNEEL switch is in the YES (up)
position.
C
LO
SE
OP
EN
Delay Feature: When activating
the OPEN functions using the
outside key entry, the key unlocks
the door and then there is a
two
second delay before the Enter-
van power functions are acti-
vated. This delay feature
only
occurs when activating the
outside key entry and
only occurs
during the OPEN function.
1. Press MANUAL/AUTO switch
to MANUAL position.
2. Pull detent pin.
3. Pull red handled lever fully.
4. Insert detent pin in lever hole.
Note: Pull detent pin, return lever
to original position and press
MANUAL/AUTO switch to AUTO
position before performing electric
procedures.
KNEEL ACTUATOR
MANUAL RELEASE
Use only if vehicle will not
raise electrically.
52215
MANUAL
AUTO
MANUAL
AUTO
Kneel Actuator Manual Release
Assembly
Kneel Actuator MANUAL/AUTO Switch
The Kneel Actuator MANUAL/
AUTO switch is mounted in the
Kneel Actuator Manual Release
assembly. The Kneel Actuator
Manual Release assembly is
located behind the driver's side
slide door. This switch
must be
in the AUTO position before the
electromechanical power kneeling
system can be activated. The
MANUAL/AUTO switch
must be
pressed to the MANUAL position
in order to manually release the
kneel actuator.
Do not press this switch to the
MANUAL position unless you
have experienced kneel actuator
power or equipment failure.
See
pages 23 and 24 for further details.
Kneel Actuator MANUAL/AUTO Switch
Press the black MANUAL/AUTO
switch to the MANUAL (up) position
before performing Kneel Actuator
Manual Release Procedures.
Press the black MANUAL/AUTO
switch to the AUTO (down)
position before performing auto-
matic Power Kneeling Operations.
Operation