BraunAbility EntervanII, Руководство по эксплуатации для владельца

Страница: 42 / 65

Page 40
Troubleshooting Diagnosis Chart
FUNCTION SYMPTOM POSSIBLE CAUSE REMEDY
continued continued
6.30
Faulty
Operation
6.40
Door Will
Not Close
Fully
Adjust or replace
Connect, repair or replace
Adjust or replace
Remove obstruction
Activate CLOSE control until door stops
(closes fully)
Adjust microswitch so door closes fully
or replace
Clean and lubricate with * Light Oil,
remove obstruction or otherwise correct
Connect, repair or replace
Adjust or replace
Crimp tightly
Repair
Clean and tighten
Replace fuse
Connect securely
Replace if under 8.8 volts
Replace transmitter
Match transmitter code to receiver.
Procedure: Match transmitter DIP
switches #1-#9 to receiver DIP switch
code. Transmitter DIP switch #10
must
be opposite receiver DIP switch #10.
Note: Reverse #10 switches to reverse
transmitter push button functions.
5.00
RAMP FOLD
5.23 Ramp Folded microswitch out of
adjustment or defective
5.24 See 4.33, 4.34, 4.35 and 4.36
6.11 See 1.00 and 3.10
6.12 Ramp harness disconnected or
defective
6.13 Ramp Folded microswitch out of
adjustment or defective
6.21 See 3.20
6.31 See 3.30
6.41 Obstruction in door opening
6.42 CLOSE control not activated
throughout entire door closing
function (until door stops)
6.43 Door Closed microswitch out of
adjustment or defective
6.51 Outboard ramp extension hinge
not properly lubricated, obstructed
or otherwise damaged
6.52 Ramp Folded microswitch
harness defective
6.53 Ramp Folded microswitch out of
adjustment or defective
7.11 See 1.00, 2.12, 2.13, 2.18, 2.19,
2.20 and Section 2.30
7.21 See Section 2.30
8.11 See 1.00
8.21 Wire terminals
8.22 Broken wire
8.23 Poor ground connection
8.24 Faulty fuse
8.25 Wiring harness unplugged
8.31 9 Volt battery defective
8.32 Transmitter switch defective
8.33 Transmitter replaced without
proper coding
8.34 Additional transmitter added to
system without proper coding
8.30
No Signal
(Code) Being
Transmitted
8.20
Power to
Entervan
Systems But
No Power to
Receiver
7.10
NO RAISE
Operation
6.50
Door Contacts
Ramp When
Closing
6.10
NO
CLOSE
Operation
7.00
KNEEL
SYSTEM
(RAISE)
8.10
No Operation
8.00
REMOTE
CONTROL
6.00
POWER
DOOR
(CLOSE)
5.20
Faulty Fold
Operation
continued continued
7.20
Faulty
Operation
6.20
Motor Runs - Door
Does Not Move
Troubleshooting