BraunAbility EntervanII, Руководство по эксплуатации для владельца

Страница: 16 / 65

Page 14
Pre-Operation Notes and Details
WARNING
Close slide door
before loading
and unloading
wheelchair
passengers.
52208
Door
Driver Side Slide Door
Close the driver-side slide door before loading
and unloading wheelchair passengers.
Operate
this slide door as detailed in your Chrysler-supplied
owner's manual. To provide a safer environment for
small children and wheelchair passengers, activate
the Child Protection Door Lock as outlined in your
Chrysler-supplied manual. When the child lock
system is engaged, the door can only be opened
from the outside. Always make sure the sliding door
is fully latched any time the vehicle is in motion.
Close the driver-side slide door
before loading and unloading
wheelchair passengers!
The automatic ramp can be activated by either
interior-mounted yellow OPEN/CLOSE switch, the
remote control switches or the outside key entry.
See pages 7-10 for further details regarding these
Entervan controls.
Delay Feature: After the door is fully open, a
minimum two second delay will occur before the
ramp starts to unfold. This delay feature is required
in order to utilize the
Passive (Non-Wheelchair)
Access feature. The delay allows the operator
adequate time to release the OPEN switch once the
door is open - preventing the automatic ramp
unfolding operation from starting. The ramp assem-
bly can then be manually rotated out of the vehicle
allowing passive (non-wheelchair) access to the
door opening if so desired. See page 19 for
Pas-
sive (Non-Wheelchair) Access details.
Ramp Unfolding Notes: When unfolding the ramp,
the ramp motor stops running when the ramp
reaches the
nearly -horizontal position ( approxi-
mately 6" - 8" above ground level). The ramp
continues to slowly lower the remaining distance
by the force of gravity.
When the ramp has unfolded beyond the vertical
(90
°
) position and you stop activating the DOWN
function, the ramp may continue to unfold very
slowly . This gravity-activated unfolding of the ramp
may not be visibly detected until an approximate 75
°
angle is reached.
Ramp Folding Note: You must continue to press
the CLOSE switch or turn the outside key entry key
counterclockwise through the entire ramp folding
function to fold the ramp
fully (stowed position). If
the ramp has not folded fully (beyond vertical - 90
°
position) and you stop activating the CLOSE func-
tion, the ramp may unfold (deploy) by the force of
gravity as explained above.
Manual Operation: If you experience power or
equipment failure, refer to the Door and Ramp
Manual Operating Instructions on pages 21 and
22.
Automatic Power Ramp (continued)
Operation