Bradley Terrazzo WF2613, Руководство по установке

Страница: 8 / 22

WF2613
Installation
8 3/5/2013
Bradley
• 215-1451 Rev. F; ECN 13-00-001
5a
Installing Supplies with Optional Soap Dispenser for
A/O drain units
A
B
Install hemmed end (not sharp end) of
support tube (welded seam toward wall)
with gasket onto bowl.
Install restraining bracket on the support
tube above the backsplash. Use suitable
anchors to attach to wall.
C
Connect 1/2" supply tubing to sprayhead.
• Using a sharp knife, cut tubing squarely
and remove any burrs. DO NOT pinch
or crush end of tubing.
• Loosen nut on fitting. Moisten end of
tube and push into fitting until it is firmly
seated. Tighten nut to secure tube
to fitting (make sure nut is securely
tightened).
• If connector leaks, reseat tubing
according to above procedure.
If leaking persists, replace male
connector, or call your Bradley
representative for assistance.
D
E
F
G
Place sprayhead with 1/2" tubing onto
support tube. Run tubing down through
support tube.
Assemble the lower tie rod (the longer
threaded rod), upper tie bar (notched at
corners), lower tie bar, tie rod nut, and
coupling nut, then attach the 4-1/4" tie rod
to coupling nut. Make sure upper tie rod is
postioned as shown.
Place infrared module assembly on top of
sprayhead. Rotate until infrared module
locks in with tie bar. Drop two infrared
module wires down into the pedestal.
FOR UNITS WITH SOAP OPTION: Install
the spacer, soap dispenser and cover
using the coupling nut, third tie rod (8-5/8"
long) and second coupling nut. Secure with
acorn nut and socket head set screw.
FOR UNITS WITHOUT SOAP OPTION:
Secure infrared module cover and
dispenser cover with acorn nut and socket
head set screw.
Male 1/2"
Tube
Connector
269-626
Tubing
Dispenser
Cover
Upper Tie Bar
(159-009A)
Corner Restraining
Bracket (S70-061E)
(Fits Around Support Tube)
Type "O" Drain
(Supplies from Above)
Type "A" Drain
Acorn Nut (110-052A)
and Set Screw (160-093)
Sprayhead
Soap
Dispenser
Spacer
(113-155A)
IR Module Assembly
(S83-046)
Coupling Nut (110-051D)
Set Screw (160-208)
Sprayhead
(S05-054C)
Support Tube
(S57-005)
Support Tube
Gasket (125-011)
1/2" Supply
Tube
Valve
Assembly
Hot
Cold
Tie Rod Hex Nut (110-064)
Set Screw (160-208)
Lower Tie Bar (159-009)
Lower (Longest)
Tie Rod (176-008A)
Upper Tie Bar (159-009A)
(Notched at Corners)
4-1/4" Module Tie
Rod (176-118)
Soap
Dispenser
Lid
8-5/8" Soap Tie
Rod (176-010)
Parts Shown
in Box are
for Unit
with Soap
Dispenser
Coupling Nut
(110-051D) Set
Screw (160-208)
Soap Dispenser
Gasket (124-066
Nut
For models with optional paper towel
dispensers, tie pipe assembly, or shroud,
see separate instruction sheets
Tubing