14
Euro Style Restroom Partitions, Phenolic LT — FLOAT Series
Installation
12/10/2021
Bradley •
AD3-FLOAT_Install Rev. A
11 Pre-Drilling the System
Verify the system is properly aligned before securing in place.
Pull the support leg down until it is firmly seated on the
floor . Secure the support to the floor using two 6 mm
plastic anchors and 4 .8 mm x 38 mm screws . Pre-drill
into the floor through the holes in the flange .
B
Secure the wall bracket to the end pilasters using
5 .5 mm x 25 mm pan head screws .
A
Slide the lower heavy U-bracket up, firmly under the
partition panel .
C
Use a 4 .2 mm drill bit to drill through the heavy
U-bracket at the base, and then secure the bracket in
place using 4 .8 mm x 25 mm countersunk screws .
D
Drill the upper heavy brackets in the same manner .
E
If desired, rivets can be used to secure panel to back
wall in addition to the brackets.
