67
14. While holding a 13 mm (1/2”) wrench on the Right Rear Roller Bolt steady, turn another 13 mm (1/2”) wrench on the Drive Pulley Bolt counter-clockwise. Note the
orientation of the Drive Pulley with the Round Magnet on the inside.
8. Loosen the Belt Tensioning Screws on both Treadles using 5 mm hex wrench (total of 4 screws).
NOTE:
Be sure to record how many
turns it takes to loosen the screws to assist with reassembly.
15. Remove the 3 indicated bolts from the Side Bearing Plate and Rear Plate using
two 13 mm (1/2”) wrenches. Repeat on other side of machine.
16. Remove the Side Bearing Plates and Rear Plate from the Bearing.
Side Bearing Plate Rear Plate
Right Rear Roller Bolt
Drive Pulley Bolt
