- 12 -
Electrical connection :
Powered with a 2,5mm² cross section H07RNF power cable, 2 ground supplied with the equipment.
The terminal shall be connected:
- by a qualified person.
- to an omnipole switch between the terminal and the electric network, in compliance with regulations in effect.
- in series with a high sensitivity differential device with protection against over-currents.
- to an efficient ground, in compliance with regulations in effect.
- to an equipotential conductor, not provided with the equipment, to be connected to the captive nut located low at the
back, between the two grey stops (logo
).
CONTROL PANEL
1 :
on/off switch
7 :
timers
2 :
trolley presence indicator light
8 :
programming switch
3 :
cold temperature displays
9 :
value decrease button
4 :
time displays
10 :
value increase button
5 :
manual mode switch
11 :
reheating indicator light
6 :
manual mode indicator light
12 :
temperature hold indicator light
ADJUSTING THE FEET OF THE TERMINAL
Before adjusting, remove the front protection door, and place it on the side, of the terminal as shown in the diagram (fig 1).
Fig.1
Fig.2
Open the trolley doors and fold them back against the holding magnets on the side of the trolley (fig 2).
Содержание NAV'THERM
Страница 66: ... 66 ...
Страница 67: ... 67 ...