Bosch NWC?0495, Руководство по установке

Страница: 78 / 99

EN | 77
Bosch Security Systems | 2006-05 | V2.0
Dinion IP
| Installation Manual
IP address
Enter the desired IP address for the camera in this field. The IP address must be
valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address here.
Gateway address
If you want the unit to establish a connection to a remote location in a different
subnet, enter the IP address of the gateway here. Otherwise, this field can remain
empty (0.0.0.0).
HTTP browser port
Select a different HTTP browser port from the list if required. The default HTTP
port is 80.
Video transmission
If the unit is used behind a firewall, TCP (Port 80) should be selected as the
transmission protocol. For use in a local network, choose UDP.
Note
Multicast operation is only possible with the UDP protocol. The TCP
protocol does not support multicast connections. The MTU value in UDP
mode is 1514 bytes.
Ethernet link type
If the camera is connected to the network via a switch, both devices must have
the same preset network connection type. If necessary, ask your network
administrator what value the associated switch is set to.
Choose Auto for an autosensing network connection. If necessary you can set the
value to 10 or 100 MBit/s for either full or half-duplex mode (FD or HD).
Note
Malfunctions can occur (for example image faults) if the network capacity
is not sufficient for transmission of the maximum data rate generated by
the camera.