Bosch ICP-MAP5000-2, Руководство по установке

Страница: 7 / 90

MAP 5000 Introduction | en 7
Bosch Security Systems B.V. Installation manual 2019-09 | 25 | F.01U.168.332
1 This module mounts on the ICP-MAP0025 hinged mounting plate.
2 This module mounts on the ICP-MAP0020 accessory mounting plate, which mounts to the
back of the enclosure.
3 When determining the number of power supplies, it is also necessary to take into account
the inrush current of loads (refer to Planning the system with IPP-MAP0005 power supply, page
7).
4 This assembly is only required if the IPP-MAP0005 power supply is installed.
5 When one or more ICP-MAP0010 LSN gateways are operated remotely, there must be one
IPP-MAP0005 power supply in the same enclosure.
6
Mount the enclosure directly under or at the side (top edge flush) of the control panel
enclosure.
1.5.1 Planning the system with IPP-MAP0005 power supply
Number of power supplies
To guarantee a reliable system booting, take into account the following:
–
Inrush current of the connected loads
– Current limit of the IPP-MAP0005 power supply
– Current limit of the ICP-MAP5000 main panel
Notice!
The normal operating condition is not the subject of these considerations.
Load inrush current
– IUI-MAP0001-2 control center: max. 800 mA
– ICP-MAP0010 LSN module: max. 1000 mA, AUX is switched on later
– ICP-MAP0007-2 DE module: negligible
Current limitation
– Power supply per output A / B (short-time): 3.2 A
– Main panel at external BDB: 1.6 A
Refer to Typical configuration with ICP-MAP0111 panel enclosure, page 8.
Definition of power supply segment
A power supply segment is a power supply with all loads supplied by the power supply.
Power supply segment
4-wire cables are used for load connection within the power supply segment.
The following conditions must be taken into account when planning in order to guarantee a
reliable system booting: