Bosch AutoDome, Руководство по монтажу

Страница: 10 / 24

Photo 4E
4.3 Installing and Wiring the Pendant Box
4.3.1. If wiring the pendant box from the back, feed the wires
from the back/wall plate through the two (2) separate
compartments in the bottom of the box.
4.3.2. Slide the entire box onto the four (4) carriage bolts on
the wall plate. Secure the box to the plate using two (2)
phillips head screws at the corners of the transformer
(as shown in PHOTO 4F).
Photo 4F
4.3.3. If installing the 120/230 VAC version, follow these
instructions for wiring:
a. Remove the SIGNAL and POWER connectors from the
shipping bag.
b. Strip the wires and connect (as shown in PHOTO 4G)
to the SIGNAL CONNECTOR.
c. Connect the earth ground to the green screw using the
supplied connector (in shipping bag).
d. Connect the CONTROL and POWER connectors to the
board (Typical CONTROL connection is biphase, con-
nected to C(+), C(–), and Ground using a sheilded
twisted pair, Belden 8760 or equivalent).
e. Connect the VIDEO cable to the VIDEO OUT BNC
connector.
Photo 4G
4.3.4. If the AutoTracker model is being used, there is an
additional connector on the PC board. This connector
is for the Alarm Relay output. If it is being used, strip
and connect these wires. The connector is labeled as
follows (see PHOTO 4H):
Photo 4H
NOTE:
When the AutoTracker option is installed, since it uses
RS-232 for control of the AutoDome camera, these connections
may not be used for external control.
NOTE:
If installing the fiber optic version, the BNC from the
dome is pre-wired to the fiber optic module. Simply remove
the fiber boot from the fiber connector, and attach the ST ter-
minated fiber cable originating from the control system
(PHOTO 4I).
Philips’ LTC 4629 Fiber Receiver is required at the head end sys-
tem.
ν
Optical Fiber Compatibility: 50/125 mm, 62.5/125 mm,
low loss multimode glass fiber, rated for a minimum
system bandwidth of 20 MHz (VIDEO 850
nm/CONTROL 1300 nm).
ν
Maximum Distance: 4 km (2.5 miles).
Installation EN
© 2003 Bosch Security Systems Page 10 of 24
Carriage Bolts
Carriage Bolts
Mains Power
Earth Ground
Prewired Connector
(supplied)
Video Out to
Head End
Biphase or RS-232/485
(from Control System)
Video In from
Camera
Normally Closed
Normally Open
Common
AutoTracker Option
Alarm Relay
Tighten
Screws