4.5.4. If the Alarm inputs or relay outputs are being used,
connect the appropriate stripped wires to the 8-pin
Alarm connector per FIGURE 2.
Figure 2
4.5.5. Lift the AutoDome into the Pendant Arm and align
the notch on the AutoDome with the notch on the
side of the pendant arm (see PHOTO 4M).
Photo 4M Align the Dome with the Pendant Arm
4.5.6. Twist the dome counterclockwise until it stops
turning (approximately a 90° rotation).
4.5.7. Tighten the two (2) slotted locking screws at the top
of the dome (as shown in PHOTO 4N).
Photo 4N Tighten the Screws on the Pendant Arm
Installation
EN
© 2003 Bosch Security Systems
Page 12 of 24
GND A1
A2
A3
A4
NC COM NO
8
7
6
5
4
3
2
1
ALARM CONNECTOR
ALARM GROUND
ALARM INPUT #1
ALARM INPUT #2
ALARM INPUT #3
NORMALLY OPEN
RETAINING SCREW
RELAY COMMON
NORMALLY CLOSED
ALARM INPUT #4
Align Notches
Rotate
Содержание AutoDome
Страница 23: ...EN 2003 Bosch Security Systems Page 23 of 24 ...
