
MAINTENANCE PROCEDURES
ical products present in water. It will
help to clean up sand, salt, shells or
other particles in water jackets (ex-
haust system,
intercooler (
super-
charged engines
) and hoses).
Exhaust system flushing should be
performed when the watercraft is not
expected to be used further the same
day or when the watercraft is stored
for any extended time.
NOTICE
Failure to flush the sys-
tem, when necessary, will severely
damage exhaust system. Make sure
engine operates during entire pro-
cedure.
WARNING
Perform these operations in a well
ventilated area. Certain compo-
nents in the engine compartment
may be very hot. Direct contact
may result in skin burn. Do not
touch any electrical part or jet
pump area when engine is run-
ning.
WARNING
When operating the engine while
the watercraft is out of the water,
the heat exchanger in the ride plate
may become very hot. Avoid any
contact with ride plate as burns
may occur.
Connect a garden hose to connector lo-
cated at the rear of watercraft. Do not
open water tap yet.
219001878-054_a
1. Water inlet connector
NOTE:
The following tool is recom-
mended when a quick connect adapter
is used to ease garden hose installa-
tion.
RECOMMENDED TOOL
FLUSHING
CONNECTOR
ADAPTER (P/N 295
500 473)
1
F00
E
05A
2
1. Quick connect adapter
2. Flushing connector adapter
To flush the exhaust system, start the
engine then immediately open the wa-
ter tap.
NOTICE
Always start the engine
before opening the water tap. Open
water tap immediately after engine
is started to prevent overheating.
Never run engine without supplying
water to the exhaust system when
watercraft is out of water.
Run the engine 90 seconds at idle.
NOTICE
Never run engine longer
than 2 minutes. Drive line seal has
no cooling when watercraft is out of
water.
______________
125
Содержание Sea-Doo GTX
