BOMBARDIER Sea-Doo GTX, Руководство оператора

Страница: 113 / 196

OPERATING MODES
Changing Learning Key Speed
Settings
NOTE: Changing key settings is only
available when the engine is not run-
ning.
To change learning key settings, carry
out the following:
1. Press the START/STOP button to
wake up the electrical system and
install the NORMAL key on the en-
gine cut-off switch.
2. Press the MODE button repeatedly
until KEY MODE is visible in the digi-
tal screen of the information center.
219001878-015_a
TYPICAL - GAUGE CONTROL BUTTONS
1. MODE
2. UP button
3. DOWN button
4. SET button
in
AM
RPMgal/h
lap
MESSAGE DISPLAYED
KEY MODE
3. Press the SET button once to enable
learning key mode setting function.
The display will change to L-Key.
in
AM
RPMgal/h
lap
FUNCTION SELECTED - LEARNING
KEY
1. L-KEY message
2. Learning key setting
4. Press the UP or DOWN button to
toggle the key setting between 1
and 5. See table for speed limita-
tions according to setting.
5. Press the SET button once to save
the setting, twice to exit the func-
tion, or simply wait for the function
to time-out. The change in key set-
ting will automatically be saved.
NOTE: The key speed setting is appli-
cable to any key of the same type used
on a specific watercraft. The same
key type used on a different watercraft
may therefore have a different key
speed setting.
D.E.S.S.
KEY TYPE
KEY
SPEED
SETTING
APPROX.
MAX.
SPEED
5
80 KM/H
(50 MPH)
4
74 km/h
(46 MPH)
3
68 km/h
(42 MPH)
2
60 km/h
(37 MPH)
LEARNING
KEY
1
51 km/h
(32 MPH)
______________
111