Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
20
7.5.
Check machine functions
Before starting the check machine functions, you must read
the chapter „
Machine operation
“. Do not carry out check
machine functions, if you do not comprehend me aning of all
buttons and all machine functions.
Check, if the machine or some parts of the machine were not
damaged during transport.
Check, if covers are installed and functional.
Check by means of the Tenzomat (see
Special accessory
),
if the saw band is correctly stretched. If it is necessary, you
can stretch the saw band according to chapter „
Selection
and replacement of the saw band
“. Values of the saw band
stretching are on the Tenzomat.
Switch on the main switch and check the motor s and systems
(saw band drive, hydraulic pump, cooling pump, chips
conveyor).
Open and close the main vice and the feeding vice. Drive the
front feeder from the front position to the rear position. Turn
the saw frame of the band saw from one outer pos ition to
other outer position. Raise the saw frame to the top position
and drop the saw frame to the lowest position.
Start the machine with the cooling pump and let it run without
load until the cooling system will be filled with cooling liquid.
As soon as the cooling liquid starts to escape from the
nozzles of the cooling system, the cooling system is ready
for the operation.
Carry one cycle of cutting without material. Check, if the
machine runs with no irregularities. If all machine functions
are right, the machine is ready for operation.