Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
26
11.
Semi-automatic cycle
1)
Lift the saw arm to the top position by pressing button „
8
“.
2)
Open the vice by pressing button „
7
“.
3)
Clamp material to
the vice by pressing button „
6
“.
4)
Lower the frame about 10 mm above the material by
button „
9
“.
ATTENTION!
Do not move the saw frame to the material,
when the saw band driving is not running! Do not move the
saw frame to the material with accelerated motion! The saw
band can be damaged!
5)
Select the max. heigth of the arm with limit switch.
6)
Set the saw band speed according to the kind of the
cutting material.
7)
Set the speed of the arm sinking by adjust governing valve
„
15
“.
8)
You can clear the register of the performed cycles by
button
5
– 6
second stop on
.
9)
Press button „
4
“ (
START
of semi-automatic cycle).
Note:
Press button „
5“
(
STOP
of semi-automatic cycle). In
risk of injury or damage of the band saw, pr ess the
emergency button
TOTAL STOP “10”
.
10)
The band saw clamps the material to the vice and it
makes the cut.
11)
Open the vice. If the vice is not opened, you can open it
by button „
7
“. Remove the blank.
12)
You can repeat whole process.
