Version 1.05 / June 2008
BOMAR, spol. s r.o.
Extend 900.720
Těžební 1236/1
62700 Brno
CZECH REPUBLIC
12
TOTAL STOP button
TOTAL STOP button is used for emergency switching
– off
the machine in case defect or health hazard. By pressing
TOTAL STOP button is interrupted the supply of the
electrical power.
If any damages or fault appears, immediately press
TOTAL STOP button!
Release the pressing button is possible by twisting of the
upper part of the button.
Saw band stretching and rupturing inspection
This device checks the saw band stretching and causes
immediate machine shut
– down in the event the band
ruptures.
The device contains limit switch. Its setting is described in
ch
apter “Service and Adjusting”. Check the stretching
carefully and periodically
– eventually adjust. To stretch the
saw band press the left button (left arrow). To release the
saw band press the right button (right arrow). Stretching
value is set by the producer.
Left cover
It covers tightening wheel. If the cover is opened during
operation, the limit switch is opened and the band saw is
stopped. The band saw is not possible start in set mode.
The band saw is stated to the operation, when the cov er is
closed!
Right cover
It covers driving wheel. If the cover is opened during
operation, the limit switch is opened and the band saw is
stopped. The band saw is not possible start in set mode.
The band saw is stated to the operation, when th e cover is
closed!
