Bomar Ergonomic 320.250 DG, Руководство по эксплуатации

Страница: 53 / 115

53
Údržba stroj
e
Wartu
ng
Machine service
3. Pull both guide rollers from their eccentrics.
4. Put new guide rollers on the eccentrics and screw the eccentrics to the guide
cube.
5. Now insert a test piece of saw band (cca 15 - 20 cm) into the guide cube. Adjust
both eccentrics so that the band runs in the middle of milled groove. This groove
is located between both eccentrics. Guide rollers may not press too much on the
band, but they must spin freely.
6. Install the cube on the gib. Install the saw band and adjust guiding cubes.
4.8.3. Round brush replacement
If the chip removing brush is so worn, that it does not fulfil its function, the brush must
be replaced.
1. Release the nut of the brush, exchange old brush to new brush and screw on the
nut of the brush.
2. Set the brush to the saw band.
Attention!
Vice must has aluminum jaws or should be placed in a vice
aluminum produc, that avoid damage to the pin during
clamping.
Optimal distance between band and roller is 0,05mm.