Bomar Ergonomic 320.250 DG, Руководство по эксплуатации

Страница: 45 / 115

45
Údržba stroj
e
Wartu
ng
Machine service
4. Secure the stop screw with nut and check the switch setting once more
ATTENTION!
If the band is stretched to the value according the TENZOMAT but the holder of thstop
screw is not situated on the boundary of the red and green colour, it is necessary to
stick the sticker in the correct place.
4.4.7. Saw frame lower position stop adjustment
The lower stop limits the lowest position of the saw frame. This stop point has to be
checked at least once a month. If the lower stop point is wrongly adjusted, the cutting
table can be deeply cut or the material will not be cut completely
1. Move the saw frame to the upper position
2. Release the nut of the adjusting screw and adjust the stop point by adjusting the
screw
3. Fasten the adjusting screw with the nut again
4. Set the limit switch of the lower arm position
4.4.8. Adjustment of the limit switch of saw frame lower stop point
If you have adjusted the lower stop point of the saw frame, the limit switch adjustment
inspection is required
Check setting
Lower the arm to the lowest position. If the arm lays on the lower stop and the switch
reacts, the setting is correct. In other case carry out the switch setting
Switch setting