Bomar Ergonomic 320.250 DG, Руководство по эксплуатации

Страница: 33 / 115

33
Ovládá
ní str
o
je
Bedi
en
ung
der
Masch
ine
Machine control
3.3. Machine control
3.3.1. Cutting
1. Open the vice of the band saw.
2. Set the length stop to the desired length of the material.
3. Set the desired cutting angle.
4. Insert the material and pull it to the length stop.
upnout
spannen
tighten
povolit
lösen
loosen
5. Pull vice jaws about 5 mm from the material by hand wheel.
6. Tighten the material by the clamping lever.
7. Set the saw band speed.
8. Start saw band drive by button START .
9. Set the speed of the saw frame sinking.
10. Close the governing valve of the frame sinking and lift the saw frame to the top
position after cutting
11. Remove the cut. Now you can repeat whole progress.
3.3.2. Setting of the material length
Release the securing screw, move the length stop on the desired length of the material
and fasten the securing screw..
Note:
Saw band drive is possible to stop by button STOP or by button
TOTAL STOP in emergency causes during cutting.
ATTENTION! Saw frame sinking is possible to stop by governing
valve closing!
By pressing button TOTAL STOP
is not stopped saw frame
sinking!
Note:
The length stop makes bounce listel of the material, so that the
saw band will be not compressed in the cut. Turn the lever to the
arrow direction..